Forged Wheel Hubs
A wheel hub carries vertical load, cornering side force and braking torque through its bearing seats. Runout at the flange face translates directly into brake judder and uneven tyre wear, so dimensional discipline matters as much as strength.
- Hub Diameter
- 120 mm – 450 mm
- Weight Range
- 3 kg – 45 kg
- Materials
- SAE 1045, EN8, EN19
- Bearing Seat Tolerance
- ±0.02 mm
- Runout Control
- Verified per setup
- Applications
- Trucks, trailers, tractors, buses
Forged Wheel Hubs at a glance
Quotable facts from Avadh Techno Forge, Gundasara, Gondal, Rajkot.
- Hub Diameter: 120 mm – 450 mm
- Weight Range: 3 kg – 45 kg
- Materials: SAE 1045, EN8, EN19
- Bearing Seat Tolerance: ±0.02 mm
- Runout Control: Verified per setup
- Applications: Trucks, trailers, tractors, buses
Bearing Seats and Runout
Inner and outer bearing seats are machined in one setup so they stay coaxial, and flange face runout is measured on every setup change. This is the difference between a hub that runs quietly for a decade and one that returns as a warranty claim.
- Coaxial bearing seats, single setup
- Flange face runout controlled
- Stud hole pattern to PCD drawing
- Balanced material distribution
Stud Holes and Mounting Interface
Stud hole pattern, PCD and pilot diameter are machined to the wheel specification and gauge verified. Hole edges are chamfered so stud seating is repeatable when the wheel is torqued in service.
Material and Duty
SAE 1045 and EN8 normalised suit trailer duty; alloy grades quenched and tempered are used where axle loads and braking energy are higher.
Topics covered on this page
- forged wheel hub manufacturer India
- hub forging supplier
- trailer wheel hub India
- wheel hub manufacturer Rajkot
Based on work carried out at our own forging plant at Gundasara, Gondal, Rajkot — operating since 2008.
Questions Answered
Do you machine bearing seats to interference fit tolerance?
+
Yes, seats are held to ±0.02 mm and verified with bore gauges against the bearing specification.
Can you drill stud holes to our PCD?
+
Yes, stud pattern, PCD and pilot diameter are machined to your drawing and gauge checked.
What weight range do you cover?
+
3 kg to 45 kg finished hub weight.
Do you supply hubs with studs pressed in?
+
Stud pressing can be included in the supply scope on request.