Forged Pump Components
Pumps combine rotating loads, pressure containment and often corrosive fluid in a single machine. Forged shafts and housings deliver the fatigue strength and pressure integrity that keep a pump running between scheduled overhauls instead of between breakdowns.
- Shaft Length
- Up to 1,500 mm
- Materials
- EN19, EN24, SS 304/316/410
- Seal Seat Finish
- Ra 0.4 µm ground
- Runout Control
- Verified after grinding
- Components
- Shafts, hubs, casings, glands
- Applications
- Centrifugal and reciprocating pumps
Forged Pump Components at a glance
Quotable facts from Avadh Techno Forge, Gundasara, Gondal, Rajkot.
- Shaft Length: Up to 1,500 mm
- Materials: EN19, EN24, SS 304/316/410
- Seal Seat Finish: Ra 0.4 µm ground
- Runout Control: Verified after grinding
- Components: Shafts, hubs, casings, glands
- Applications: Centrifugal and reciprocating pumps
Pump Shafts Under Combined Load
A pump shaft carries torsion, bending from hydraulic side load, and axial thrust simultaneously, all while spinning at speed. Forged shafts in EN19, EN24 or SS 410 provide the fatigue margin that a bar-turned shaft cannot guarantee.
- Combined torsion and bending duty
- Ground bearing and seal seats
- Straightness verified after hardening
- Corrosion-resistant grade options
Seal Faces and Gland Areas
Mechanical seal seats demand tight surface finish and runout control. We grind these areas rather than turn them, because seal life is decided by the quality of the surface running against the seal face.
Materials for Corrosive Service
SS 304, SS 316 and SS 410 for chemical and water applications; duplex grades where chloride attack is a concern. Grade selection is confirmed by spectro analysis on every heat lot.
Topics covered on this page
- forged pump components India
- pump shaft forging manufacturer
- impeller hub forging supplier
- pump parts manufacturer Rajkot
Based on work carried out at our own forging plant at Gundasara, Gondal, Rajkot — operating since 2008.
Questions Answered
Do you make stainless steel pump shafts?
+
Yes, SS 410, SS 304 and SS 316 shafts are forged and ground regularly for water and chemical service.
Are seal seats ground?
+
Yes, ground to Ra 0.4 µm with runout verified, because seal life depends on that surface.
Can you make pump parts from a worn sample?
+
Yes, via reverse engineering including grade identification by spectro analysis.
What is your minimum quantity for pump components?
+
Single pieces on the open die route for replacements; production batches from 200 pieces.